Short thread cutter
Setting the cutting pressure
Cover
• Open the throat plate slide ( p. 21)
Fig. 70: Setting the cutting pressure
(1) - Thread-pulling knife
(2) - Marking
To set the cutting pressure:
1. Swing out the thread-pulling knife (1) until the marking (2) is next to
2. Loosen the screw (6).
3. Place the counter blade (5) in position against the thread-pulling knife (1).
4. Tighten the screw (6).
Service Instructions 1767 - 00.0 - 12/2016
⑤
②
the cutting edge of the counter blade (5).
(5) - Counter blade
(6) - Screw
⑥
①
87