Setting The Needle Position After Sewing Stop; Activating Sewing Foot Lift After Thread Cutter; 10Activating Sewing Foot Lift After Sewing Stop - Dürkopp Adler 1767 Service Instructions Manual

19.2.8 Setting the needle position after sewing stop

You can determine where the needle is positioned after a sewing stop.
There are two options:
• Top dead center (needle position 2)
• Bottom dead center (needle position 1)
To activate the top dead center after a sewing stop:
1. Press
 The LED illuminates; i.e., the needle is raised after a sewing stop.
If the needle is to be in the bottom dead center after a sewing stop, press

19.2.9 Activating sewing foot lift after thread cutter

The sewing foot lift after thread cutter lifts the sewing foot after the thread
is cut.
To activate the sewing foot lift after thread cutter:
1. Press
 The LED illuminates.

19.2.10Activating sewing foot lift after sewing stop

The sewing foot lift after sewing stop lifts the sewing foot after a sewing
stop.
To activate the sewing foot lift:
1. Press
 The LED illuminates.
100
.
again.
.
.
Programming
Service Instructions 1767 - 00.0 - 12/2016