Table of Contents
Advertisement
Fig. 36: Aligning the needle bar linkage sideways (3)
8. Align the thread lever (5) relative to the arm shaft crank (9).
There is an equal amount of space on either side.
9. Tighten both threaded pins (8) on the arm shaft crank (9).
Order
Then check the following settings:
• Distance between hook and needle ( p. 52)
50
Once the tensioning plate has been assembled, the thread lever (5)
is positioned in the center of the slot.
Aligning the needle bar linkage
Service Instructions 1767 - 00.0 - 12/2016
Advertisement
Table of Contents
