17.1 Setting the locking latch
Proper setting
1. Turn the handwheel until the roller (2) is at the highest point of the
2. Press the roller (2) against the control cam (3).
The locking latch (1) can be swung out without clamping, and the
Fig. 67: Setting the locking latch
(1) - Locking latch
(2) - Roller
(3) - Control cam
To set the locking latch:
1. Loosen the nut (4).
2. Turn the screw (5) and set the distance.
3. Tighten the nut (4).
84
control cam (3).
distance between the locking latch (1) and locking pin (6) is not
greater than 0.1 mm.
①
②
③
Short thread cutter
(4) - Nut
(5) - Screw
(6) - Locking pin
Service Instructions 1767 - 00.0 - 12/2016
⑥
⑤
④