Feed Dog; Setting The Feed Dog Position - Dürkopp Adler 1767 Service Instructions Manual

Feed dog

9
The position and the movement of the feed dog and needle bar have to
be coordinated such that the needle pierces exactly in the center of the
needle hole of the feed dog.
Order
First, check the following setting:
• Needle bar linkage ( p. 48)

9.1 Setting the feed dog position

Proper setting
When the stitch length is set to 0, the feed dog is exactly in the center of
the throat plate cutout, both sideways and in the sewing direction.
The needle must enter the needle hole precisely in the center.
Various settings can be made depending on how far the position of the
feed dog differs from the correct setting:
Service Instructions 1767 - 00.0 - 12/2016
Feed dog
CAUTION
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you set the feed dog
position.
• For minimal deviations, it suffices to move the feed dog on the
carrier ( p. 42)
• If this is not sufficient, move the entire feed dog carrier on the
sliding shaft ( p. 43)
41