3. Swivel the thread-pulling knife (6) forward until the circle mark is exactly
4. Set the handwheel position to 60°.
5. Push the control cam (3) to the left up against the clamping ring (2).
6. Turn the control cam (3) such that the roller (1) runs up at the contour
7. Tighten the threaded pins (4).
8. Check setting:
80
next to the tip of the counter blade (5).
of the control cam (3) and the widest extent of the control cam is at
handwheel position 60° at the highest point.
• Insert the thread into the thread-pulling knife (6) and slowly turn the
handwheel.
• Check the handwheel position at which the thread is cut.
• If necessary, repeat setting steps 1 – 7 until the cut takes place
at 60°.
Thread cutter
Service Instructions 1767 - 00.0 - 12/2016