Table of Contents
Advertisement
Winder
The position of the arms on the screw (2) determines the filling quantity:
3. Turn the screw (2):
4. Put the completely filled bobbin onto the winder.
5. Fold the winder lever (3) upwards as far as it will go to the thread.
Setting the winder spacing
Fig. 55: Setting the winder spacing
(3) - Winder lever
(5) - Block
(6) - Winder wheel
(11) - Thread-pulling knife
To set the winder spacing:
6. Turn the winder spindle (12) such that the thread-pulling knife (11) is
7. Loosen the threaded pin in the block (5).
8. Set the winder lever (3) such that the upper arm is above the marking
The distance between the winder lever and the outer thread on the
9. Set the block (5) such that it is resting against the locking disk (14).
10. Set the block (5) such that its distance to the winder wheel (6) is 0.5 mm.
11. Tighten the threaded pin in the block (5).
Service Instructions 1767 - 00.0 - 12/2016
• Parallel: Automatic winding stop at 0.5 mm below the edge of the
winder
• Closer together: Automatic stop with larger filling quantity
• Further apart from each other: Automatic stop with smaller filling
quantity
• Arms closer together: Turn counterclockwise
• Arms further apart from each other: Turn clockwise
at the top right and is facing the right-hand screw hole (13).
for the XXL hook (15).
bobbin is 2 – 3 mm.
(12) - Winder spindle
(13) - Right-hand screw hole
(14) - Locking disk
71
Advertisement
Table of Contents
