Programming
19.2.2 Setting the multiple start bartack
Use the multiple start bartack to set the number of stitches as well as the
number of repetitions (sections with forward and backward stitches).
To set the multiple start bartack:
1. Press
The LED flashes. If it illuminates, the multiple start bartack has been
2. Press the A+ button from the Programming button group repeatedly
3. Press the B+ button repeatedly until the required number of backward
4. Press the D+ button repeatedly until the required number of repetitions
5. Confirm your selection with
19.2.3 Using the multiple start bartack as the darning program
Information
The darning program is only supported by certain classes.
Order
If you want to use the multiple start bartack as the darning program, it has
to be released in advance by qualified specialists.
The darning program offers the following functions:
• The thread is cut at the end of the program.
To set the darning program:
1. Check whether the thread cutter
2. Press
The LED illuminates.
3. Press the A+ button from the Programming button group repeatedly
4. Press the B+ button repeatedly until the required number of backward
5. Press the C+ button to set the start of path 1.
6. Press the D+ button repeatedly until the required number of repetitions
Service Instructions 1767 - 00.0 - 12/2016
.
activated as the darning program and has to be deactivated ( p. 97).
until the required number of forward stitches is reached.
stitches is reached.
is reached.
.
until the required number of forward stitches is reached.
stitches is reached.
is reached.
.
has been activated.
97