Disassembling And Assembling The Feed Dog - Dürkopp Adler 1767 Service Instructions Manual

Working basis

3.3.10 Disassembling and assembling the feed dog

Fig. 10: Disassembling and assembling the feed dog
(1) - Feed dog
(2) - Feed dog carrier
Disassembling the feed dog
To disassemble the feed dog:
1. Disassemble the throat plate ( p. 22).
2. Loosen the screws (3).
3. Take the feed dog (1) off the feed dog carrier (2).
Assembling the feed dog
To assemble the feed dog:
1. Place the feed dog (1) onto the feed dog carrier (2).
2. Tighten the screws (3).
3. Insert the throat plate ( p. 22).
Important
Check the feed dog position in its movement at maximum stitch length
(depending on the equipment: 6, 9 or 12) by turning the handwheel.
The feed dog must not hit against the throat plate.
Service Instructions 1767 - 00.0 - 12/2016
CAUTION
Risk of injury from sharp and moving parts!
Puncture or crushing possible.
Switch off the machine before you disassemble or
assemble the feed dog.
(3) - Screws
23