Table of Contents
Advertisement
9.2.4 Setting the compensating weight
Correct setting
Handwheel position 210°:
Cover
• Tilt the upper section backwards
Figure 31: Setting the position of the compensating weight
Setting steps
1. Put the handwheel into the 210° position.
2. Loosen the setscrew (1) on the compensating weight (2) using a 3 mm
3. Leave the hex key inserted in the setscrew.
4. Turn the compensating weight (2) such that the setscrew (1) is parallel
5. Tighten the setscrew (1) on the compensating weight (2).
40
WARNING
Risk of crushing
Switch the sewing machine off before you check and set the
position of the compensating weight.
The setscrew for the compensating weight is parallel to the base plate.
(
Section 4.4.1 Access to the machine bottom section, page 10)
(1) - Setscrew
(2) - Compensating weight
hex key.
to the base plate (3). Use the hex key inserted in the setscrew as a
means of orientation.
(3) - Base plate
Service manual H867 Version 00.0 - 08/2013
Setting the feed-dog
Advertisement
Table of Contents
