Ricoh G108 Service Manual page 123

Rev. 12/2004
5990 [SP print mode]
5990 001 All (Data List)
5990 002 SP (Mode Data List)
5990 004 Logging
5990 005 Diagnosis Report
5990 006 Non-Default
5990 007 NIB Summary
⇒
Dew Removal [ON or OFF/OFF/-]
5993
5993 001 Performs a free-run on the laser optics unit to ensure that dew does not form on
the components of the unit.
"ON": Performed every time the main power is turned ON.
Requires System Firmware version 1.04 or later
⇒
SP5-994-001: CTL-Fan: [ON or OFF/ ON/-]
5994
5994 001 Stops the controller fan or lets it continue at job end.
"OFF": Stops the fan 5 seconds after job end.
NOTE: If the HDD is installed, do not turn this SP OFF.
Requires System Firmware version 1.04 or later
⇒
5995 SP5-995-001: Fine_Mode [ 0 or 1/ 0 / - ] This SP has been added to reduce
banding:
5995 001 0: OFF
1: ON
NOTE: When this SP is ON, the machine feeds a sheet into the development unit
only after the sheet before it leaves the fusing unit. The print time for one sheet is
3.75 sec longer than normal mode.
Requires System Firmware version 1.03 or later
5996 LD Power
5996 001 [K] Over All
5996 002 [C] Over All
5996 003 [M] Over All
5996 004 [Y] Over All
5997 Fuser SC Clear
DFU
5998 Engine Memory Clear
5.1.4
SM
SERVICE PROGRAM MODE
Executes Engine SP5-990-002, 004, 005, 006,
and 007.
Prints an SMC report on all SP modes.
Prints an SMC report on the SPs that save logs.
Prints the Self-Diagnosis Report.
Prints an SMC report on the SPs whose
settings are different from the defaults.
Prints the network configuration report.
[-35 ∼ +35 / 0 / 5/step]
Adjusts the LD power. When you specify a
greater value, the toner density and the
thickness of the color is intensified. Note that
coloration (calibration) can be changed if you
change the value of a color.
5-21 G108