Move Exec - Ricoh G108 Service Manual

5.3.2 MOVE EXEC

Slot 1 refers to the upper SD-card slot [A.] Slot 2
refers to the lower SD-card slot [B].
The service program "Move Exec" (Engine SP5-
873-001) lets you copy application programs from
the original SD card to another SD card. The
application programs are copied from the SD card
in Slot 1 to the SD card in Slot 2. Note that the
authentication data is also copied with the
application program (
1. Turn off the main power switch.
2. Make sure that a blank SD card is in Slot 2. The
application program is copied to this SD card.
3. Prepare the SD card that currently holds the
application program.
4. Turn the SD card's "face" [C] to the left side of
the machine. Then insert it into Slot 1 [A]. The
application program is copied from this SD card.
5. Turn on the main power switch.
6. Start the SP mode.
7. Set Engine SP5-873-001 "Move Exec."
8. Follow the instruction on the operation panel.
9. Exit SP mode.
10. Turn off the main power switch.
11. Remove the SD card from Slot 1.
12. Turn on the main power switch.
13. Make sure that the application programs operate correctly.
SM
5.3.1).
5-45
SD CARD APPLI MOVE
[C]
[A]
[B]
G108S903.WMF
G108