Paper Jam - Ricoh G108 Service Manual

PAPER JAM

3.2 PAPER JAM
The table below lists some possible symptoms for paper jams.
Symptom
The paper stops after it has been fed
halfway into the duplex unit.
The paper is output to the paper tray. The
message "Remove Misfeed Duplex Unit" is
shown.
The paper stays in the fusing unit after the
second-side image is printed.
A paper jam occurs when the trailing edge is
near paper sensor 1.
A paper jam occurs when the trailing edge is
near paper sensor 2.
A paper jam occurs when the leading edge
is near the entrance roller.
G390
[A]
G390T901.WMF
20
Possible Cause
The duplex unit is incorrectly installed. The
screws behind the rear paper guide [A] are
not fastened ( Option Setup Guide).
The paper gate solenoid does not work
correctly ( 1.9, 2.3).
The paper gate solenoid does not work
correctly ( 1.9, 2.3).
Connector CN106 is not connected (
Connector CN107 is not connected (
Connector CN102 is not connected (
3.1).
3.1).
3.1).
SM