Downloading Nvram Data - Ricoh G108 Service Manual

FIRMWARE UPDATE
10. Set Engine SP5-824 (NVRAM Upload).
11. Press the Enter key. Uploading begins.
The file name below is created when uploading has completed normally:
"NVRAM" is the folder name in the SD card. "Serial_number.NV" is the file
name with the extension ".NV". The serial number of the machine is used as
the fine name. For example, if the serial number is G1080017, the file name is
"G1080017.NV."
12. Exit the SP mode.
13. Turn off the main power switch.
14. Remove the SD card.
15. Indicate (write) the machine serial number and product code on the SD card.
You will need this SD card when you download NVRAM data (
NVRAM Data).
NOTE: One SD card can contain the NVRAM data from two or more machines.

Downloading NVRAM Data

Copying the data from the SD card to the NVRAM (referred to as "to download
NVRAM data" in this section) after you replace the NVRAM, you must manually
input the necessary settings if you do not download the NVRAM data.
1. Make sure that the main power switch is off.
2. Make sure that you have the correct SD card that contains the required
NVRAM data.
3. Insert the SD card into Slot 1.
4. Turn on the main power switch.
5. Enter the SP mode.
6. Set Engine SP5-825 (NVRAM Download).
7. Push the Enter key. Downloading begins.
NOTE: Downloading will stop if the file name in the SD card is not the same as
the serial number of the machine ( Uploading NVRAM Data).
8. Exit the SP mode.
9. Turn off the main power switch.
10. Remove the SD card.
11. Turn on the main power switch.
12. Check that the NVRAM data was correctly downloaded.
G108
NVRAM\serial_number.NV
5-42
Downloading
SM