Ricoh G108 Service Manual page 118

SERVICE PROGRAM MODE
5839 IEEE 1394
5839 004* Host Name
5839 007* Cycle Master
5839 008* BCR mode
5839 009* IRM 1394a Check
5839 010* Unique ID
5839 011* Logout
5839 012* Login
5839 013* Login MAX
5840 IEEE 802.11b
5840 004* Current SSID
Enters a unique ID (up to 32 characters long) to identify the device when it is
operating in an area with another wireless LAN network.
5840 006* Channel Max
Sets the maximum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location.
The default settings are set for the maximum end of the range for each area.
Adjust the upper 4 bits to set the maximum number of channels. DFU
5840 007* Channel Min
Sets the minimum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location.
The default settings are set for the minimum end of the range for each area.
Adjust the lower 4 bits to set the minimum number of channels. DFU
5840 011* WEP key number
Selects the WEP key.
5840 018 SSID Key Check
5840 020* WEP mode
Determines the operation mode of the WEP key. Displayed only when the
option 801.11b for wireless LAN is installed.
G108
DFU
DFU
DFU
DFU
DFU
DFU
DFU
DFU
[1 to 11 or 13 / 1 / 1/step]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting
[1 to 11 or 13 / 1 / 1/step]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting
[00~11 / 00 / 1 binary]
00: Key #1
01: Key #2 (Reserved)
10: Key #3 (Reserved)
11: Key #4 (Reserved)
Checks that the specified SSID is correct. The
result is displayed on the operation panel.
NOTE: You cannot use the characters other
than 0x20 ∼ 0x7e in an SSID. This SP is
commonly used among multiple machines. This
SP is for MFP machines, which can input
incorrect characters from various keys.
[0~1/0/1]
0: Max. 64-bit (10 characters)
1: Max. 128-bit (10, 26 characters)
5-16 SM