Table of Contents
Advertisement
Alarm notification
When setting up the rules for alarm detection, you can specify how you want the recorder to
notify you about an alarm or event. You can select more than one notification type.
Not all notifications types are available for all types of alarms.
You can quickly check the system status by looking at the status LEDs on the front panel.
The alarm notification types are:
•
Enable Alarm Audio: Triggers an audible beep when a notification or alarm is detected by
the system or a camera.
•
Notify Alarm Host: Sends a signal to TruVision Navigator or other software applications
when an alarm or notification is detected.
•
Send Email: Sends an email when an alarm or notification is detected. See "Email settings"
on page 66 for information on how to configure the recorder to send an email.
•
Upload Snapshots to FTP: Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
•
Trigger Alarm Output: Triggers an alarm output or multiple alarm outputs when a
notification is detected for an external alarm.
To set up alarm notifications:
1. From the menu toolbar, click
Setup
> Notifications.
2. Set the priority between a text insertion event and a motion alarm if both are triggered at the
same time. By default is it always
3. Select an alarm notification type. See the list above.
4. Check one or more response method: Enable Alarm Audio, Notify Alarm Host, Send Email
Note: The list of options available depends on the alarm selected.
5. Select the alarm outputs to be triggered when an alarm notification
6. Repeat steps 2 and 6 for other notification types.
7. Click
Save
to save the settings.
Event notifications
Event notifications appear in the Notification Center.
The different types of events notifications are:
•
HDD Full: All installed HDDs are full and will not record any more video.
•
HDD Error: Errors occurred while files were being written to the HDD, there is no HDD
installed, or the HDD had failed to initialize.
•
Network Disconnected: Disconnected network cable.
TruVision NVR 70 User Manual
Configuration
>
Remote Configuration
Text In >
Motion.
12BChapter 13: Alarm and event setup
>
Alarm & Event
detected.
81
Advertisement
Table of Contents
