Table of Contents
Advertisement
14BChapter 15: Storage management
7.
Close and re-lock the front panel.
Note: The HDDs must be installed BEFORE powering up the unit. The drives are defaulted
to a single HDD group that is automatically ready to record once cameras are added and
configured with recording schedules.
8. Apply the supplied label to the recorder chassis. Place it next to the original label without
covering it.
Note: Failure to install the label will affect the warranty of the recorder.
9. Initialize the new HDDs, if needed. See "Initialize a HDD" on page 92.
Storage mode
To ensure an efficient use of the storage space available on HDDs, you can control an
individual camera's storage capacity using HDD quota management. This function lets you
allocate different storage capacities for both recordings and snapshots to each camera.
Note: If the overwrite function is enabled, the maximum capacity for both recordings and
snapshots is set to zero by default.
To set the HDD quota for a camera:
1. From the menu toolbar, click
Management
>
Storage
2. Under the Mode option, select Quota.
94
Configuration
>
Mode.
Remote Configuration
>
Storage
TruVision NVR 70 User Manual
Advertisement
Table of Contents
