Table of Contents
Advertisement
10BChapter 11: Network settings
4. Ask your ISP service provider for your DNS server address or look it up in the browser
interface settings of your router.
Go to
Network Settings
well as the default gateway address.
5. Click
Apply
to save the settings and click
NTP server settings
A Network Time Protocol (NTP) server can also be configured on your recorder to keep the
date and time current and accurate.
Note: If the device is connected to a public network, you should use a NTP server that has a
time synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44) or europe.ntp.pool.org. If the device is setup in a more customized network,
NTP software can be used to establish a NTP server used for time synchronization.
To set up an NTP server:
1. From the menu toolbar, click
> NTP.
2. Check the NTP box to enable feature. It is disabled by default.
3. Enter the NTP settings:
•
Interval (min): Time in minutes to synchronize with the NTP server. The value can be
between 1 and 10080 minutes. Default is 60 minutes.
•
NTP Server: IP address of the NTP server.
•
NTP Port: Port of the NTP server.
4. Click
Save
to save the settings and click
Email settings
The recorder can send email notifications of alarms or notifications through the network.
Note:
Ensure that the DNS address has been set up correctly beforehand.
To configure email settings:
1. From the menu toolbar, click
> Email.
2. Enter the required settings.
Option
Enable Server Authentication Check the box if your mail server requires authentication and enter the login
User Name
66
and enter the preferred and alternate DNS server addresses as
Exit
Configuration
>
Exit
to return to live view.
Configuration
>
Description
user name and password.
If the mail server requires authentication, enter the login user name.
to return to live view.
Remote Configuration
Remote Configuration
>
Network Settings
>
Network Settings
TruVision NVR 70 User Manual
Advertisement
Table of Contents
