Table of Contents
Advertisement
1BChapter 2: Physical installation
•
AC power cords
•
Recorder
•
Hard drive kits
•
CD with software and manuals
•
TruVision NVR 70 Quick Start Guide
•
TruVision NVR 70 User Manual (on CD)
•
TruVision Recorder Operator Guide (on CD)
Back panel description
The figure below shows the back panel connections and describes each connector on a typical
TVN 70 network video recorder. Details may vary for specific models.
Before powering up the recorder, connect a main monitor for basic operation. Once all required
connections are done, enter the relevant data in the setup wizard (see page 10).
Note: For every hardwired alarm input, connect one wire to the input connection with the alarm
number label and one wire to a Ground connection (labeled G).
Figure 1: TVN 70 back panel connections
Description
1.
One audio output
2.
One audio input
8
Use
Connect to speakers for audio output.
Connect a microphone for bi-directional
audio (not recorded)
Specification
RCA jack, 315mV, 600 ohms.
Unbalanced.
Line-level audio requires amplification.
RCA jack, 315 mV, 40 kohms.
Unbalanced.
Line-level audio requires amplification.
TruVision NVR 70 User Manual
Advertisement
Table of Contents
