Radius Server - EnGenius EWS Series User Manual

Gigabit managed smart switch with wireless controller
Hide thumbs Also See for EWS Series:
Table of Contents

Advertisement

RADIUS Server

RADIUS proxy servers are used for centralized administration. Remote Authentication Dial In User Service
(RADIUS) is a networking protocol that provides centralized Authentication, Authorization, and
Accounting (AAA) management for users that connect and use a network service for greater convenience.
RADIUS is a server protocol that runs in the application layer, using UDP as transport. The Network
Switch with port-based authentication and all have a RADIUS client component that communicates with
the RADIUS server. Clients connected to a port on the Switch must be authenticated by the
Authentication server before accessing services offered by the Switch on the LAN. Use a RADIUS server
to authenticate users trying to access a network by relaying Extensible Authentication Protocol over LAN
(EAPOL) packets between the client and server. The RADIUS server maintains a user database, which
contains authentication information. The Switch passes information to the configured RADIUS server,
which can authenticate a user name and password before authorizing use of the network.
Index
Displays the index for which RADIUS server is displayed.
Server IP
Enter the RADIUS server IP address.
Authorized Port
Enter the authorized port number. The default port is 1812.
Accounting Port
Enter the name you wish to use to identify this Switch.
Key String
Enter the key string used for encrypting all RADIUS communication between the
device and the RADIUS server.
Timeout Reply
Enter the amount of time the device waits for an answer from the RADIUS
server before switching to the next server. The default value is 3.
Retry
Enter the number of transmitted requests sent to the RADIUS server before a
failure occurs. The default is 3.
Server Priority
Enter the priority for the RADIUS server.
Dead Timeout
Enter the amount of time that the RADIUS server is bypassed for service
requests. The default value is 0.
Click the Apply button
to accept the changes or the Cancel button
to discard them.
175

Advertisement

Table of Contents
loading

Table of Contents