EnGenius EWS Series User Manual page 101

LACP Settings
Assign a system priority to run with Link Aggregation Control Protocol (LACP) and is become for a backup
link if a link goes down. The lowest system priority is allowed to make decisions about which ports it is
actively participating in in case a link goes down. If two or more ports have the same LACP port priority,
the port with the lowest physical port number will be selected as the backup port. If a LAG already exists
with the maximum number of allowed port members, and LACP is subsequently enabled on another
port using a higher priority than an existing member, the newly configured port will replace the existing
port member that has a lower priority. A smaller number indicates a higher priority level. The range is
from 0-65535 and default is: 32768.
System Priority
Click Apply to save settings.
Enter the LACP priority value to the system. The default is 32768 and the
range is from 1 to 65535.
101