Basic, Logging, Web And Radius Parameters; Table 6-1: Basic, Logging, Web And Radius Parameters (Continues On Pages 91 To 98) - Nortel Mediant TP-1610 SIP User Manual

6.6

Basic, Logging, Web and RADIUS Parameters

Note:
Table 6-1: Basic, Logging, Web and RADIUS Parameters (continues on pages 90 to 97)
ini File Field Name
Web Parameter Name
EthernetPhyConfiguration
DHCPEnable
[Enable DHCP]
EnableDiagnostics
EnableLanWatchDog
[Enable LAN Watchdog]
DNSPriServerIP
[DNS Primary Server IP]
DNSSecServerIP
[DNS Secondary Server IP]
Mediant 2000 SIP User's Manual
In Table 6-1, parameters in brackets are the format in the Embedded Web
*
Server .
*
0 = 10 Base-T half-duplex
1 = 10 Base-T full-duplex
2 = 100 Base-TX half-duplex
3 = 100 Base-TX full-duplex
4 = auto-negotiate (Default)
Auto-negotiate falls back to half-duplex mode (HD) when the opposite port is not in
auto-negotiate, but the speed (10 Base-T, 100 Base -TX) in this mode is always
configured correctly.
0 = Disable DHCP support on the gateway (default).
1 = Enable DHCP support on the gateway.
After the gateway is powered up, it attempts to communicate with a BootP server. If a
BootP server is not responding and if DHCP is enabled, then the gateway attempts to
get its IP address and other network parameters from the DHCP server.
Web Note: After you enable the DHCP Server (from the Web browser) follow this
procedure:
Click the Submit button.
•
Save the configuration using the 'Save Configuration' button (before you reset
•
the gateway). For information on how to save the configuration, refer to Section
5.12 on page 84.
• Reset the gateway directly (Web reset doesn't trigger the BootP/DHCP
procedure and the parameter DHCPEnable reverts to '0').
Note that throughout the DHCP procedure the BootP/TFTP application must be
deactivated. Otherwise, the gateway receives a response from the BootP server
instead of the DHCP server.
Note: The DHCPEnable is a special "Hidden" parameter. Once defined and saved in
flash memory, its assigned value doesn't revert to its default even if the parameter
doesn't appear in the ini file.
0 = No diagnostics (default)
1 = Perform diagnostics
0 = Disable LAN Watch-Dog (default).
1 = Enable LAN Watch-Dog.
If LAN Watch-Dog is enabled, the gateway restarts when a network failure is
detected.
IP address of the primary DNS server in dotted format notation.
IP address of the secondary DNS server in dotted format notation.
Valid Range and Description
90
Mediant 2000 SIP
Document #: LTRT-72504