Protocol Management; Protocol Definition Parameters; Coders; Figure 5-3: Coders Screen - Nortel Mediant TP-1610 SIP User Manual

Nortel networks voip media gateway user's manual
Table of Contents

Advertisement

5.8

Protocol Management

Use this menu to configure the gateway's SIP parameters and tables.
5.8.1

Protocol Definition Parameters

Use this submenu to configure the following gateway's specific SIP protocol parameters:
General Parameters
Proxy & Registration Parameters
Coders (refer to Section
DTMF & Dialing Parameters
5.8.1.1

Coders

From the Coders screen you can configure the first to fifth preferred coders (and their
corresponding ptimes) for the gateway. The first coder is the highest priority coder and is used by
the gateway whenever possible. If the far end gateway cannot use the coder assigned as the first
coder, the gateway attempts to use the next coder and so forth.
To configure the gateway's coders, take these 6 steps:
Open the 'Coders' screen (Protocol Management menu > Protocol Definition submenu >
1.
Coders option); the 'Coders' screen is displayed.
From the coder drop-down list, select the coder you want to use. For the full list of available
2.
coders and their corresponding ptimes, refer to the ini file parameter 'CoderName'
(described in
Note: Each coder can appear only once.
From the drop-down list to the right of the coder list, select the size of the Voice Packet
3.
(ptime) used with this coder in milliseconds. Selecting the size of the packet determines how
many coder payloads are combined into one RTP (Real-Time Transport Protocol) (voice)
packet.
Note 1: The ptime packetization period depends on the selected coder name.
Note 2: If not specified, the ptime gets a default value.
Note 3: The ptime specifies the maximum packetization time the gateway can receive.
Repeat steps 2 and 3 for the second to fifth coders (optional).
4.
Click the Submit button to save your changes.
5.
To save the changes so they are available after a power fail, refer to Section
6.
84.
Note:
Mediant 2000 SIP User's Manual
5.8.1.1
below)

Figure 5-3: Coders Screen

Table
6-3).
Only the ptime of the first coder in the defined coder list is declared in
Invite/200 OK SDP, even if multiple coders are defined.
44
Mediant 2000 SIP
5.12
on page
Document #: LTRT-72504

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mediant 2000

Table of Contents