Table of Contents
Advertisement
Mediant 2000 SIP User's Manual
Table 6-6: E1/T1/J1 Configuration Parameters (continues on pages 122 to 127)
ini File Field Name
Web Parameter Name
ISDNGeneralCCBehavior
[General Call Control Behavior]
ISDNOutCallsBehavior
[Outgoing Calls Behavior]
ISDNIBehavior_x
[Q.931 Layer Response
Behavior]
ISDNInCallsBehavior_x
[Incoming Calls Behavior]
ISDNOutCallsBehavior_x
[Outgoing Calls Behavior]
Version 4.4
*
16 = The gateway clears down the call if it receives a Notify message specifying
'User-Suspended'. A Notify (User-Suspended) message is used by some networks
(e.g., in Italy or Denmark) to indicate that the remote user has cleared the call,
especially in the case of a long distance voice call.
32 = Applies only to ETSI E1 lines (30B+D). Enables handling the differences
between the newer QSIG standard (ETS 300-172) and other ETSI-based standards
(ETS 300-102 and ETS 300-403) in the conversion of B-channel ID values into
timeslot values:
•
In 'regular ETSI' standards, the timeslot is identical to the B-channel ID value,
and the range for both is 1 to 15 and 17 to 31. The D-channel is identified as
channel-id #16 and carried into the timeslot #16.
•
In newer QSIG standards, the channel-id range is 1 to 30, but the timeslot range
is still 1 to 15 and 17 to 31. The D-channel is not identified as channel-id #16,
but is still carried into the timeslot #16.
When this bit is set, the channel ID #16 is considered as a valid B-channel ID, but
timeslot values are converted to reflect the range 1 to 15 and 17 to 31. This is the
new QSIG mode of operation. When this bit is not set (default), the channel_id #16 is
not allowed, as for all ETSI-like standards.
1024 = Numbering plan / type for T1 IP Tel calling number are defined according to
the manipulation tables or according to RPID header (default). Otherwise, the Plan /
type for T1 calls are set according to the length of the calling number
Same as the description for parameter 'ISDNBehavior' for a specific trunk ID (x = 0 to
7)
Same as the description for parameter 'ISDNInCallsBehavior' for a specific trunk ID
(x = 0 to 7)
Same as the description for parameter 'ISDNOutCallsBehavior' for a specific trunk ID
(x = 0 to 7)
6. ini File Configuration of the Mediant 2000
Valid Range and Description
127
July 2005
Advertisement
Table of Contents
