When using a DC terminal block crimp connector, take these 3 steps:
Remove the DC adaptor (screw connection type) that is attached to the Mediant 2000 rear
1.
panel.
Connect the two insulated wires to the correct DC power supply. Ensure that the connections
2.
to the DC power supply maintain the correct polarity (refer to
Insert the terminal block into the DC inlet located on the Mediant 2000.
3.
2 screws for
connecting the
crimp terminal
block to the
Mediant 2000 rear
panel
Mediant 2000 SIP User's Manual
Figure 3-8: DC Terminal Block Screw Connector
Figure 3-9: DC Terminal Block Crimp Connector
34
Mediant 2000 SIP
Figure
3-9).
Document #: LTRT-72504