Nortel Mediant TP-1610 SIP User Manual page 126

Table 6-6: E1/T1/J1 Configuration Parameters (continues on pages 122 to 127)
ini File Field Name
Web Parameter Name
ISDN Flexible Behavior Parameters
ISDN protocol is implemented in different Switches / PBXs by different vendors. Several implementations vary a little
from the specification. Therefore, to provide a flexible interface that supports these ISDN variants, the ISDN behavior
parameters are used.
ISDNInCallsBehavior
[Incoming Calls Behavior]
ISDNIBehavior
[Q.931 Layer Response
Behavior]
Mediant 2000 SIP User's Manual
*
2048 = Sends Channel ID in the first response to an incoming Q.931 Call Setup
message. Otherwise, the Channel ID is sent only if the gateway requires to change
the proposed Channel ID (default).
8192 = Sends Channel ID in a Q.931 Call Proceeding message.
65536 = Includes Progress Indicator (PI=8) in Setup ACK message, if an empty
called number is received in an incoming Setup message. Applicable to overlap
dialing mode. The parameter also directs the gateway to play a dial tone (for
'DialToneDuration'), until the next called number digits are received.
262144 = NI-2 second redirect number – Users can select and use (in Invite
messages) the NI-2 second redirect number, if two redirect numbers are received in
Q.931 Setup for incoming Tel IP calls.
Note: To configure the gateway to support several 'ISDNInCallsBehavior' features,
summarize the individual feature values. For example to support both '2048' and
'65536' features, set 'ISDNInCallsBehavior = 67584.
1 = Q.931 Status message isn't sent if Q.931 received message contains an
unknown/unrecognized IE(s). By default the Status message is sent. This parameter
applies only to PRI variants in which sending of Status message is optional.
2 = Q.931 Status message isn't sent if an optional IE with invalid content is received.
By default the Status message is sent. This parameter applies only to PRI variants in
which sending of Status message is optional.
4 = Accepts unknown/unrecognized Facility IE. Otherwise, (default) the Q.931
message that contains the unknown Facility IE is rejected. This parameter applies to
PRI variants where a complete ASN1 decoding is performed on Facility IE.
128 = Connect ACK message is sent in response to received Q.931 Connect.
Applicable only to Euro ISDN User side outgoing calls. Otherwise, the Connect ACK
is not sent (default).
512 = Enables to configure T1 NFAS Interface ID (refer to the parameter
'ISDNNFASInterfaceID_x'). Applicable to 4/5ESS, DMS, NI-2 and HKT variants.
2048 = Always set the Channel Identification IE to explicit Interface ID, even if the B-
channel is on the same trunk as the D-channel. Applicable to 4/5ESS, DMS and NI-2
variants.
65536 = Applicable to ETSI, NI-2 and 5ESS. The calling party number (octet 3a) is
always present even when presentation and screening are at their default.
131072 = Clears the call on reception of Q.931 Status with incompatible state.
Otherwise, (default) no action is taken.
Note: To configure the gateway to support several 'ISDNIBehavior' features,
summarize the individual feature values. For example to support both '512' and
'2048' features, set 'ISDNIBehavior = 2560'.
Valid Range and Description
126
Mediant 2000 SIP
Document #: LTRT-72504