5.9
Advanced Configuration
Use this menu to set the gateway's advanced configuration parameters (for advanced users
only).
5.9.1
Configuring the Network Settings
From the Network Settings page you can define:
•
IP settings.
•
NTP settings.
•
Syslog settings.
•
SNMP settings.
•
RTP settings.
•
Ethernet Ports Information (read-only).
To configure the Network Settings parameters, take these 4 steps:
Open the 'Network Settings' screen (Advanced Configuration menu > Network Settings);
1.
the 'Network Settings' screen is displayed.
Configure the Network Settings parameters.
2.
Click the Submit button to save your changes.
3.
To save the changes so they are available after a power fail, refer to Section
4.
84.
Note that the default RTP Base UDP Port is 6000.
Mediant 2000 SIP User's Manual
Figure 5-14: Network Settings Screen
62
Mediant 2000 SIP
5.12
on page
Document #: LTRT-72504