Figure 5-5: Tel To Ip Routing Table Screen; Table 5-3: Tel To Ip Routing Table - Nortel Mediant TP-1610 SIP User Manual

Nortel networks voip media gateway user's manual
Table of Contents

Advertisement

Alternative Routing' table, the gateway immediately initiates a call to the redundant
destination using the next matched entry in the 'Tel to IP Routing' table. Note that if a domain
name in this table is resolved to two IP addresses, the timeout for Invite retransmissions can
be reduced by using the parameter 'Number of RTX Before Hotswap'.
Note: If the alternative routing destination is the gateway itself, the call can be configured to
be routed back to PSTN. This feature is referred to as "PSTN Fallback", meaning that if
sufficient voice quality is not available over the IP network, the call is routed through legacy
telephony system (PSTN).
Tip:
To configure the Tel to IP Routing table, take these 6 steps:
Open the 'Tel to IP Routing' screen (Protocol Management menu > Routing Tables
1.
submenu > Tel to IP Routing option); the 'Tel to IP Routing' screen is displayed (shown in
Figure
In the 'Tel to IP Routing Mode' field, select the Tel to IP routing mode (refer to
2.
In the 'Routing Index' drop-down list, select the range of entries that you want to edit.
3.
Configure the Tel to IP Routing table according to
4.
Click the Submit button to save your changes.
5.
To save the changes so they are available after a power fail, refer to Section
6.
84.
Parameter
Destination Phone Prefix
Source Phone Prefix
Mediant 2000 SIP User's Manual
Tel to IP routing can be performed either before or after applying the number
manipulation rules. To control when number manipulation is done, set the
RouteModeTel2IP parameter. For information on this parameter, refer to refer
to
Table 6-5
on page 115.
5-5).

Figure 5-5: Tel to IP Routing Table Screen

Table 5-3: Tel to IP Routing Table

Description
Each entry in the Destination Phone Prefix fields represents a called telephone
number prefix. The prefix can be 1 to 19 digits long. An asterisk (*) represents all
numbers.
Each entry in the Source Phone Prefix fields represents a calling telephone number
prefix. The prefix can be 1 to 19 digits long. An asterisk (*) represents all numbers.
Table
5-3.
50
Mediant 2000 SIP
Table
6-5).
5.12
on page
Document #: LTRT-72504

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mediant 2000

Table of Contents