Corrective Action:
Alarm:
OID:
Default Severity
Event Type:
Probable Cause:
Alarm Text:
Status Changes:
Condition:
Alarm status:
Condition:
Alarm status:
Corrective Action:
Alarm:
OID:
Default Severity
Event Type:
Probable Cause:
Alarm Text:
Status Changes:
Condition:
Alarm status:
Condition:
Alarm status:
Corrective Action:
Alarm:
OID:
Default Severity
Event Type:
Probable Cause:
Alarm Text:
Status Changes:
Note:
Condition:
Alarm status:
Mediant 2000 SIP User's Manual
Table L-2: acBoardConfigurationError Alarm Trap
Inspect the run-time specific string to determine the nature of the configuration error. Fix
the configuration error using the appropriate tool: Web interface, EMS, or ini file. Save
the configuration and if necessary reset the device.
Table L-3: acBoardTemperatureAlarm Alarm Trap
acBoardTemperatureAlarm
1.3.6.1.4.1.5003.9.10.1.21.2.0.3
Critical
equipmentAlarm
temperatureUnacceptable (50)
Board temperature too high
Temperature is above 60 degrees C (140 degrees F)
Critical
After raise, temperature falls below 55 degrees C (131 degrees F)
Cleared
Inspect the system. Determine if all fans in the system are properly operating.
Table L-4: acBoardEvResettingBoard Alarm Trap
acBoardEvResettingBoard
1.3.6.1.4.1.5003.9.10.1.21.2.0.5
Critical
equipmentAlarm
outOfService (71)
User resetting board
When a soft reset is triggered via the Web interface or SNMP.
Critical
After raise
Status stays critical until reboot. A clear trap is not sent.
A network administrator has taken action to reset the device. No corrective action is
required.
Table L-5: acFeatureKeyError Alarm Trap
acFeatureKeyError
1.3.6.1.4.1.5003.9.10.1.21.2.0.6
Critical
processingErrorAlarm
configurationOrCustomizationError (7)
Feature key error
Support of this alarm is pending
A feature key error has been detected
Critical
272
Mediant 2000 SIP
Document #: LTRT-72504