Table of Contents
Advertisement
Click the Close Window button.
After modifying the parameters:
7.
To apply the changes to the selected trunk only, click the Apply Trunk Settings button.
To apply the changes to all the trunks, click the Apply to all Trunks button.
The screen is refreshed, parameters become read-only (indicated by being grayed). The
Stop Trunk button appears at the bottom of the screen.
To save the changes so they are available after a power fail, refer to Section
8.
84.
Note:
To reset the Mediant 2000, refer to Section
9.
5.9.4
Configuring the TDM Bus Settings
To configure the TDM Bus Settings parameters, take these 5 steps:
Open the 'TDM Bus Settings' screen (Advanced Configuration menu > TDM Bus
1.
Settings); the 'TDM Bus Settings' screen is displayed.
Configure the TDM Bus Settings parameters.
2.
Click the Submit button to save your changes.
3.
To save the changes so they are available after a power fail, refer to Section
4.
84.
A device reset is required to activate the TDM Bus Settings parameters. To reset the
5.
Mediant 2000, refer to Section
Note:
Refer to
Appendix E
'TDM Bus Enable Fallback' and 'TDM Bus PSTN Auto Clock' parameters.
Mediant 2000 SIP User's Manual
Some parameter configuration options require a device reset; when this is the
case, the Web Interface prompts the user.
5.12
on page 84.
:
Figure 5-18
TDM Bus Settings Screen
Usually the 'PCM Law Select' parameter is set to A-law for E1 trunks and to
µ-law for T1 trunks.
on page
205
for information on configuring the 'TDM Bus Clock Source',
5.12
on page 84.
68
Mediant 2000 SIP
5.12
on page
5.12
on page
Document #: LTRT-72504
Advertisement
Table of Contents
