Table of Contents
Advertisement
Mediant 2000 SIP User's Manual
L.1.2
Component: AlarmManager#0
Alarm:
OID:
Default Severity
Event Type:
Probable Cause:
Alarm Text:
Status Changes:
Condition:
Alarm status:
Condition:
Alarm status:
Note:
Corrective Action:
L.1.3
Component: EthernetLink#0
Alarm:
OID:
Default Severity
Event Type:
Probable Cause:
Alarm Text:
Status Changes:
Condition:
Alarm status:
<text> value:
Condition:
Alarm status:
<text> value:
Condition:
Alarm status:
Corrective Action:
Version 4.4
Table L-9: acActiveAlarmTableOverflow Alarm Trap
acActiveAlarmTableOverflow
1.3.6.1.4.15003.9.10.1.21.2.0.12
Major
processingErrorAlarm
resourceAtOrNearingCapacity (43)
Active alarm table overflow
Too many alarms to fit in the active alarm table
major
After raise
Status stays major until reboot. A clear trap is not sent.
The status stays major until reboot as it denotes a possible loss of information until the
next reboot. If an alarm is raised when the table is full, it is possible that the alarm is
active, but does not appear in the active alarm table.
Some alarm information may have been lost, but the ability of the device to perform its
basic operations has not been impacted. A reboot is the only way to completely clear a
problem with the active alarm table. Contact your first-level group.
Table L-10: acBoardEthernetLinkAlarm Alarm Trap
acBoardEthernetLinkAlarm
1.3.6.1.4.1.5003.9.10.1.21.2.0.10
Critical
equipmentAlarm
underlyingResourceUnavailable (56)
Ethernet link alarm: <text>
Fault on single interface
major
Redundant link is down
Fault on both interfaces
critical
No Ethernet link
Both interfaces are operational
cleared
Ensure that both Ethernet cables are plugged into the back of the system. Inspect the
system's Ethernet link lights to determine which interface is failing. Reconnect the cable
or fix the network problem
275
L. SNMP Traps
July 2005
Advertisement
Table of Contents
