Table of Contents
Advertisement
In the URL field, append the suffix 'AdminPage' (note that it's case-sensitive) to the IP
2.
address, e.g., http://10.1.229.17/AdminPage.
Click Image Load to Device; the Image Download screen is displayed (shown in
3.
F-3).
Click the Browse button in the Send Logo Image File from your computer to the Device
4.
box. Navigate to the folder that contains the logo image file you want to load.
Click the Send File button; the file is sent to the device. When loading is complete, the
5.
screen is automatically refreshed and the new logo image is displayed.
Note the appearance of the logo. If you want to modify the width of the logo (the default
6.
width is 339 pixels), in the Logo Width field, enter the new width (in pixels) and press the
Set Logo Width button.
To save the image to flash memory so it is available after a power fail, refer to Section
7.
on page 84.
The new logo appears on all Web Interface screens.
Tip:
To replace the default logo with your own corporate image via the ini
file, take these 2 steps:
Place your corporate logo image file in the same folder as where the device's ini file is
1.
located (i.e., the same location defined in the BootP/TFTP configuration utility). For detailed
information on the BootP/TFTP, refer to
Add/modify the two ini file parameters in
2.
Section
Note that loading the device's ini file via the 'Configuration File' screen in the Web Interface
doesn't load the corporate logo image files as well.
Mediant 2000 SIP User's Manual
Figure F-3: Image Download Screen
If you encounter any problem during the loading of the files, or you want to
restore the default images, click the Restore Default Images button.
6.2
on page 87.
Appendix B
on page 189.
Table F-1
according to the procedure described in
208
Mediant 2000 SIP
Figure
5.12
Document #: LTRT-72504
Advertisement
Table of Contents
