Click the submenu links to check/view a specific channel's parameter settings.
2.
5.10.3 Activating the Internal Syslog Viewer
The Message Log screen displays Syslog debug messages sent by the gateway.
Note that it is not recommended to keep a 'Message Log' session open for a prolonged period
(refer to the Note below). For prolong debugging use an external Syslog server, refer to Section
9.2
on page 165.
Refer to the Debug Level parameter 'GwDebugLevel' (described in
Syslog logging level.
To activate the Message Log, take these 4 steps:
In the General Parameters screen under Advanced Parameters submenu (accessed from
1.
the Protocol Management menu), set the parameter 'Debug Level' to 5. This parameter
determines the Syslog logging level, in the range 0 to 5, where 5 is the highest level.
Open the 'Message Log' screen (Status & Diagnostics menu > Message Log); the
2.
'Message Log' screen is displayed.
Mediant 2000 SIP User's Manual
Figure 5-26: Channel Status Details Screen
Figure 5-27: Message Log Screen
76
Mediant 2000 SIP
Table
6-1) to determine the
Document #: LTRT-72504