Advanced Communications Configuration; Configuring Advanced Communication Settings For An Isdn Connection - Nortel BayStack Instant Internet 100-S Using Manual

Chapter 8

Advanced communications configuration

This chapter describes how to configure advanced communication settings for a
dial-up, ISDN, T1, E1, or PPPoE connection. Both the T1 and E1 interfaces allow
you to configure a backup ISDN connection to the internet in case your primary
connection fails.
Configuring advanced communication settings for an
ISDN connection
If you have an ISDN interface on the Instant Internet unit, you can configure a
backup connection phone number, bandwidth on demand settings, inbound voice
and outbound priority (100-S and 400-S units only), and the inactivity timeout.
You configure these settings through the ISDN Configuration dialog box.
To open the ISDN Configuration dialog box:
1
2
Start Setup, and if prompted, select a unit to configure.
In the Interfaces area, select the ISDN interface and then click Configure.
The ISDN Configuration dialog box opens
Using the BayStack Instant Internet Management Software Version 7.11
(Figure 101).
239