Adding A Static Route - Nortel 2360 Configuration Manual

Wlan-security switch 2300 series
Hide thumbs Also See for 2360:
Table of Contents

Advertisement

128 Configuring and managing IP interfaces and services
10.0.2.1/32
IP
10.0.2.255/32
IP
224.0.0.0/ 4
IP
This example shows dynamic routes added by WSS Software for two VLAN interfaces, 10.0.1.1/24 on VLAN 1 and
10.0.2.1/24 on VLAN 2.
This example also shows two static routes, which have a next-hop type (NH-Type) value of Router. Static routes have a
default router, listed in the Gateway field. The 0.0.0.0 destination represents a default route. Here, default router
10.0.1.17 is reachable through the subnet on VLAN 1. Route 10.0.1.1/24 resolves the static route that uses the default
router. Default router 10.0.2.17 is reachable through the subnet on VLAN 2 and route 10.0.2.1/24 resolves the static
route to that gateway.
WSS Software adds routes with next-hop types Direct and Local when you add an IP interface to a VLAN, when the
VLAN is up. Direct routes are for the locally attached subnets that the switch's IP addresses are in. Local routes are for
destination interfaces configured on the WSS itself.
WSS Software automatically adds the 224.0.0.0 route to support the IGMP snooping feature.
If a VLAN is administratively disabled or all of the links in the VLAN go down or are disabled, WSS Software removes
the VLAN's routes from the route table. If the direct route required by a static route goes down, WSS Software changes
the static route state to Down. If the route table contains other static routes to the same destination, WSS Software selects
the resolved route that has the lowest cost. In the following example, the default route to 10.0.1.17 is down, so WSS
Software selects the default route to 10.0.2.17.
WSS
# show ip route
Router table for IPv4
Destination/
Mask
0.0.0.0/ 0
0.0.0.0/ 0
10.0.2.1/24
10.0.2.1/32
10.0.2.255/32
224.0.0.0/ 4
(For more information about the fields in the output, see the
Reference.)

Adding a static route

To add a static route, use the following command:
set ip route {default | ip-addr mask | ip-addr/mask-length} default-router metric
NN47250-500 (320657-F Version 02.01)
0 Local
0 Local
0 Local
Proto
Metric
Static
1 Router
Static
2 Router
IP
0 Direct
IP
0 Direct
IP
0 Direct
IP
0 Local
Nortel WLAN Security Switch 2300 Series Command Line
vlan:2:ip:10.0.1.1/24
vlan:2:ip:10.0.1.1/24
MULTICAST
NH-Type
VLAN:Interface
Gateway
10.0.1.17
Down
10.0.2.17
vlan:2:ip
vlan:2:ip
vlan:2:ip:10.0.1.1/24
vlan:2:ipp:10.0.1.1/24
MULTICAST

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

23502361Wlan 2382

Table of Contents