Table of Contents
Advertisement
5.3 Via the CLI: Debug command group
Traceconfig command
E-DOC-CTC-20051017-0169 v0.1
The traceconfig command sets the level of debugging messages that are dumped
to the screen. This is shown below:
[ipsec debug]=>traceconfig level
none
high
[ipsec debug]=>traceconfig level medium
[ipsec debug]=>
You can check the Phase 1 and 2 specific information being exchanged during
tunnel setup via following command when you activate the tracing: Press <CRTL-
Q>. In the tracing a lot of very detailed protocol information, exchanged during
tunnel setup, is shown. Each tunnel negotiation/rekeying will echo these traces on
the screen. You can stop the trace listing typing <CTRL-S>. You can clear the
message buffer typing <CTRL-T>.
Troubleshooting SpeedTouch™ IPSec
low
Chapter 5
medium
167
Advertisement
Table of Contents
