Set Or Modify The Peer Parameters - THOMSON SpeedTouch 608WL Configuration Manual

4.4.4 Set or modify the peer parameters

modify command
Example
E-DOC-CTC-20051017-0169 v0.1
ipsec peer modify
The
In this example, the parameters of the previously defined peer, named peer1, are
set:
[ipsec peer]=>
[ipsec peer]=>modify
name = peer1
[remoteaddr] = 200.200.0.1
[backupaddr] =
[exchmode] = main
[localid] = 100.100.0.1
[remoteid] = 200.200.0.1
[phyif] =
abcd
loop
[phyif] = DIALUP_PPPOE
[descr] =
AES_SHA1
3DES_MD5
AES_SHA1_Adv
[descr] = peerdes1
[auth] = secret1
[client/server] =
[options] =
:IPSec peer modify name=peer1 remoteaddr=200.200.0.1 exchmode=main loca
lid=(addr)100.100.0.1 remoteid=(addr)200.200.0.1
phyif=DIALUP_PPPOE descr=peerdes1 auth=secret1
[ipsec peer]=>
list
Use the command to verify the results of the operation:
[ipsec peer]=>list
[peer1]
Remote Address
Backup Remote Address: <unset>
Physical IF
Exchange Mode
Local Identifier
Remote Identifier
Descriptors
Authentication
Client/Server
Options
[ipsec peer]=>
Configuration via the Command Line Interface
command sets or modifies the peer parameters.
DIALUP_PPPOE
AES_MD5
DES_SHA1
peerdes1
: 200.200.0.1
: DIALUP_PPPOE
: main
: (addr)100.100.0.1
: (addr)200.200.0.1
: peerdes1
: secret1
: <unset>
: <unset>
Chapter 4
eth0
3DES_SHA1
DES_MD5
125