Set Or Modify The Connection Parameters - THOMSON SpeedTouch 608WL Configuration Manual

4.7.4 Set or Modify the Connection Parameters

modify command
Example
E-DOC-CTC-20051017-0169 v0.1
ipsec connection modify
The
parameters.
In this example, the parameters of the previously defined Connection, named
connect1, are set:
[ipsec connection]=>modify
name = connect1
[peer] = peer1
[localnetwork] =
retrieve_from_server
[localnetwork] = net1
[remotenetwork] = net2
[alwayson] = disabled
[descr] =
AES_HMAC-SHA1_TUNNEL
AES_HMAC-MD5_PFS_TUNNEL AES_HMAC-SHA1_Adv_TUNNE 3DES_HMAC-SHA1_TUNNEL
3DES_HMAC-MD5_TUNNEL
DES_HMAC-SHA1_TUNNEL
cnctdes1
[descr] = cnctdes1
[options] =
[state] = enabled
:IPSec connection modify name=connect1 peer=peer1 localnetwork=net1 rem
otenetwork=net2
descr= cnctdes1
[ipsec connection]=>
Use the list command to verify the results of the operation:
[ipsec connection]=>list
[connect1]
Peer
Local network
Remote network : net2
Always on
Descriptors
Options
State
[ipsec connection]=>
Configuration via the Command Line Interface
command sets or modifies the Connection
black_ip
AES_HMAC-MD5_TUNNEL
3DES_HMAC-SHA1_PFS_TUNN 3DES_HMAC-MD5_PFS_TUNNE
DES_HMAC-MD5_TUNNEL
: peer1
: net1
: disabled
: cnctdes1
: <unset>
: enabled
Chapter 4
net1
AES_HMAC-SHA1_PFS_TUNNE
NullEnc_HMAC-SHA1_TUNNE
147