Configure Address Translation On The Cli - THOMSON SpeedTouch Configuration Manual

6.2 Configure address translation on the CLI

Introduction
Configuring Hyper-NAT
on the CLI
How to enable/disable
address translation on
an interface
E-NIT-CTC-20040716-0004 v1.0
This covers following topics:
Configuring Hyper-NAT on the CLI
How to enable/disable address translation on an interface
How to create an address translation mapping
How to create a template
With the CLI command
:nat help,
nat help
Following commands are available :
ifconfig : Modify address translation on an IP interface.
iflist : Display all interfaces.
mapadd : Add an address mapping to a nat enabled interface.
mapdelete : Delete an address mapping from a nat enabled interfa
ce.
maplist : Display address mappings.
tmpladd : Add an address mapping template.
tmpldelete : Delete an address mapping template.
tmpllist : Display address mapping templates.
tmplinst : Instantiate address mapping templates for a given dy
namic
address.
config : Display/Modify global NAT configuration.
flush : Flush current NAT configuration.
{Administrator}=>
shows all the interfaces and there state.
:iflist
=>:nat iflist
Interface NAT
loop disabled
Internet enabled
lan1 transparent
wan1 enabled
dmz1 disabled
guest1 disabled
ppp_pppoa disabled
With the command
:nat ifconfig
translation state of an interface.
=>:nat ifconfig intf=ppp_pppoa translation=enabled
Configure address translation on the CLI
you can see all nat commands.
, it is possible to modify the address
37