4.6.3 Set the Network Descriptor Parameters
modify command
Example
E-DOC-CTC-20051017-0169 v0.1
ipsec connection network modify
The
Network Descriptor parameters.
In this example, the parameters of the previously defined network, named net1, are
set:
[ipsec connection network]=>
[ipsec connection network]=>modify
name = net1
[type] =
address
[type] = subnet
[ip] = 10.0.0.0/24
[proto] =
ah
ggp
icmp
rdp
udp
6to4
[proto] =
[port] =
at-echo
at-zis
biff
chargen
discard
doom
finger
[port] =
:IPSec connection network modify name=net1
[ipsec connection network]=>
In the example above, the network is defined as an IP subnet 10.0.0.0/24. No
protocol or port number are selected. The TAB key was used to show the supported
entries for the proto and port parameters.
list
Use the
command to verify the results of the operation:
[ipsec connection network]=>list
[net1] : subnet 10.0.0.0/24
[ipsec connection network]=>
Configuration via the Command Line Interface
command sets or modifies the
subnet
egp
gre
igmp
rsvp
vines
at-nbp
auth
bootpc
clearcase
dns
echo
ftp
Chapter 4
range
esp
hmp
pup
tcp
xns-idp
at-rtmp
bgp
bootps
daytime
domain
exec
...
139