Table of Contents
Advertisement
5 Troubleshooting SpeedTouch™ IPSec
Introduction
In this section
E-DOC-CTC-20051017-0169 v0.1
IPSec is a complex protocol suite and therefore the SpeedTouch™ offers a number
of troubleshooting methods.
Both the Web pages and the CLI interface allow you to check whether a tunnel setup
was successful or has failed.
Via the CLI you can check the Syslog messages showing you the history of tunnel
negotiation. Each Syslog message has a timestamp attached.
By contacting the SpeedTouch™ using the SNMP protocol, you can access the
IPSec MIB containing a lot of detailed tunnel information.
The following topics are discussed in this section:
5.1 Via the Debug Web pages
5.2 Via the CLI: Show command group
5.3 Via the CLI: Debug command group
5.4 Via SNMP
Troubleshooting SpeedTouch™ IPSec
Topic
Chapter 5
Page
162
165
167
170
161
Advertisement
Table of Contents
