THOMSON SpeedTouch 608WL Configuration Manual page 171

Syslog messages
E-DOC-CTC-20051017-0169 v0.1
The following table shows the syslog messages.
Severity Contents
ERROR unable to delete old SPD entry
ERROR Peer local ID not configured
ERROR unable to delete SPD entry
NOTICE invalid certificate <REASON>
INFO new phase 2 sa: from <IPADDRESS/PORT>
INFO Cert status unknown; no ISAKMP <to/from> <ip-address>
INFO Cert not usable; no ISAKMP <to/from> <ip-address>
INFO added SPDB entry: (<DIRECTION>) <IPRANGE> ->
<IPRANGE> (if <IP_IFINDEX>)
INFO added SADB entry: dir(<DIRECTION>) spi(<SPI>)
enc(<ENC_ALG>) auth(<AUTH_ALG>)
INFO connection profile <PROFILE_NAME> in use
INFO establish request for connection <PROFILE_NAME>
INFO Cannot create authentication. Maximum licensed number
<NUMBER> has already been reached.
INFO Cannot create peer. Maximum licensed number
<NUMBER> has already been reached.
INFO peer profile <PROFILE_NAME> in use
INFO Cannot create connection. Maximum licensed number
<NUMBER> has already been reached.
INFO phase <1|2> sa delete: ID(local:<ID> remote:<ID>)
INFO phase 2 sa delete: from <IPADDRESS/PORT?
INFO new phase <1|2> sa: ID(local:<ID> remote:<ID>)
INFO Cannot create IKE session. Maximum licensed number
<NUMBER> has already been reached.
INFO Certificate not found
INFO delete SADB spi(in 0x<SPI>/ out 0x<SPI>)
INFO delete SPDB spi(in 0x<SPI>/ out 0x<SPI>)
INFO ipsec <DIRECTIOM> drop: <IPADDRESS> -> <IPADDRESS>
proto <PROTOCOL_NUM> spi <SPI> seq <SEQ> reason
<REASON>
Chapter 5
Troubleshooting SpeedTouch™ IPSec
169