Procedure
E-DOC-CTC-20051017-0169 v0.1
In order to set up a basic IPSec configuration, the following main steps have to be
executed.
1
Prepare the Peer attributes:
Define a valid Authentication Attribute
Define a valid Peer Security Descriptor
2
Create a new Peer entity
3
Modify the Peer parameters
4
Prepare a valid Connection Security Descriptor.
5
Prepare a valid Network Descriptor.
6
Create a new Connection.
7
Set the parameters of the new Connection.
Refer to the corresponding Peer
Refer to the relevant Connection Security Descriptor
Modify the Connection parameters
8
Start the Connection.
Each of these steps is explained in more detail in the subsequent sections. The
order of these sections corresponds to the sequence of the configuration steps.
Configuration via the Command Line Interface
Chapter 4
103