Table of Contents
Advertisement
Chapter 4
Configuration via the Command Line Interface
4.8.3 Clear Command Group
What is it used for
clear session
156
This command group comprises two commands, intended for clearing Security
Associations:
clear all
clear session
The clear command group is accessed in the following way:
=>
=>ipsec
[ipsec]=>clear
[ipsec clear]=>
clear all
This command clears all active Phase 1 and Phase 2 Security Associations for all
defined peers. The command has no associated parameters. The successful
execution of the command is notified to the user.
[ipsec clear]=>all
ok.
[ipsec clear]=>
After clearing, the individual Security Associations can be established
again, either by starting connections, or triggered by traffic complying with
the policy.
This command clears the IKE Security Association and all active Phase 2 Security
Associations for one particular peer.
The peer is indicated by its name. The result of the command is notified to the user.
In the following example no Security Association was active for the peer, named
peer1, at the time of execution of the command:
[ipsec clear]=>session
name = peer1
:IPSec clear session name=peer1
Failed to find session for peer peer1
[ipsec clear]=>
E-DOC-CTC-20051017-0169 v0.1
Advertisement
Table of Contents
