Table of Contents
Advertisement
Chapter 3
Configuration via Local Pages
Identification &
Interface
44
The Identification & Interface fields have to be filled out with the following
information:
Local ID Type and Local ID:
The Local ID identifies the local SpeedTouch™ during the Phase 1 negotiation
with the remote Security Gateway. This identity must match the settings in the
remote Security Gateway in order to successfully set up the IKE Security
Association. The identity types supported in the SpeedTouch™ are listed in
the table below.
Remote ID Type and Remote ID:
The Remote ID identifies the remote Security Gateway during the Phase 1
negotiation. This identity must match the settings in the remote Security
Gateway in order to successfully set up the IKE Security Association. The
identity types supported in the SpeedTouch™ are listed in the table below.
Identity type
IP address
Fully qualified domain
name
User fully qualified domain
name
Distinguished name
Key identity
If you encounter problems during the IKE negotiations, use the Debug >
Logging page to verify that the Identity Type and Identity of the two peer
Security Gateways correspond with each other.
Keyword
Examples
addr
10.0.0.1
fqdn
sales.corporate.net
userfqdn
john.doe@corporate.net
dn
dc=corpor,uid=user
keyid
myid
E-DOC-CTC-20051017-0169 v0.1
Advertisement
Table of Contents
