Set Or Modify The Vpnserver Parameters - THOMSON SpeedTouch 608WL Configuration Manual

Chapter 6
Advanced Features

6.5.3 Set or modify the vpnserver parameters

modify command
186
ipsec peer vpnserver modify
The
vpnserver entity parameters.
Example
In this example, the parameters of the previously defined vpnserver entity, named
serv1, are set:
[ipsec peer vpnserver]=>modify
name = serv1
[push_ip] =
disabled
[push_ip] = disabled
[iprange] = 10.60.11.0/24
[netmask] = 255.255.255.0
[primdns] = 10.60.11.200
[secdns] = 10.60.11.201
[primwins] = 10.60.11.100
[secwins] = 10.60.11.101
[domain] = clients
[xauthpool] =
:ipsec peer vpnserver modify name=serv1 push_ip=disabled iprange=10.60.
11.0/
24 netmask=24 primdns=10.60.11.200 secdns=10.60.11.201 primwins=10.60.1
1.100 secwins=10.60.11.101 domain=clients
[ipsec peer vpnserver]=>
list
Use the
[ipsec peer vpnserver]=>list
[serv1]
Push IP
Address Range : 10.60.11.0/24
Netmask
Primary DNS
Secondary DNS : 10.60.11.201
Primary WINS
Secondary WINS: 10.60.11.101
Domain
XAuth Pool
[ipsec peer vpnserver]=>
enabled
command to verify the results of the operation:
: disabled
: 255.255.255.0
: 10.60.11.200
: 10.60.11.100
: clients
: <unset>
command sets or modifies the
E-DOC-CTC-20051017-0169 v0.1