Table of Contents
Advertisement
Chapter 4
Configuration via the Command Line Interface
4.7.1 Connection Parameters
Parameters table
Connection name
Peer [peer]
142
The table below shows the connection parameters.
Connection parameters
Parameter
Connection name
Peer
Local network
Remote network
Always-on
Descriptors
Options
State
For a basic IPSec configuration only a subset of the peer parameters need to
be set to a specified value. Some parameters may remain unset.
This symbolic name only has local significance inside the SpeedTouch™ router.
[name]
This parameter is not used in the Phase 2 negotiations with the remote Security
Gateway.
Holds the symbolic name of the peer to which the connection applies.
Keyword
Description
name
Mandatory. Symbolic name for the
connection, used internally in the
SpeedTouch™.
peer
Mandatory. Symbolic name of the peer
entity to which the IPSec connection is
set up.
localnetwork
Mandatory. The private local IP network
that has access to the IPSec connection.
remotenetwork
Mandatory. The private remote IP
network that has access to the IPSec
connection.
alwayson
Mandatory. The permanent character of
the connection can be enabled or
disabled.
descr
Mandatory.Symbolic name of the
Connection Security Descriptor.
options
Optional. Refers an option list,
containing a number of options that
influence the VPN behaviour.
state
Enables or disables the connection
E-DOC-CTC-20051017-0169 v0.1
Advertisement
Table of Contents
