Table of Contents
Advertisement
Chapter 4
Configuration via the Command Line Interface
What is ...
How is it used
In this section
110
4.3 Peer Security Descriptor
All security parameters required to establish an IKE session are grouped into a
string called a Peer Security Descriptor. This descriptor contains the methods for
message authentication, encryption and hashing, and the lifetime of the Security
Association.
The Peer Security Descriptor parameters are explained in section 4.3.1.
A Peer Security Descriptor is required as one of the parameters to successfully
create an operational Peer. The Peer refers to the Peer Security Descriptor by its
symbolic name.
A number of Peer Security Descriptors are pre-configured in the SpeedTouch™. The
user can modify these descriptors, or define additional descriptors to fit his
requirements.
The following topics are discussed in this section:
4.3.1 Peer Security Descriptor Parameters
4.3.2 List all Peer Security Descriptors
4.3.3 Create a New Peer Security Descriptor
4.3.4 Set or Modify the Peer Descriptor Parameters
4.3.5 Delete a Peer Descriptor
Topic
Page
111
114
115
116
117
E-DOC-CTC-20051017-0169 v0.1
Advertisement
Table of Contents
