Displaying Poe Power Measurement - Avaya 3500 series Getting Started

Procedure
1. Log on to ACLI in User Exec command mode.
2. At the command prompt, enter the following command:
Example
The following figure provides a sample output of the show poe-port-status command.
3524GT-PWR+#show poe-port-status
Port Status
-------------- ------
1 Enable
2 Enable
3 Enable
4 Enable
5 Enable
6 Enable
7 Enable
8 Enable
9 Enable
10 Enable
11 Enable
12 Enable
13 Enable
14 Enable
15 Enable
16 Enable
17 Enable
18 Enable
19 Enable
----More (q=Quit, space/return=Continue)----
Variable definitions
The following table describes the parameters for the show poe-port-status command.
port <portlist>

Displaying PoE power measurement

Display the voltage, current and power values for each powered device connected to each
port.
Getting Started
show poe-port-status [port <portlist>]
Admin Current
Status Classification (Watts)
--------
Detecting 0
Invalid PD 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Detecting 0
Variable
Limit
Priority----
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
32 Low
Value
Enter the ports for which you want to display
the status. If you omit this parameter, the
system displays all ports.
Displaying PoE configuration
------- ------
March 2013 83