Bootp Automatic Ip Configuration And Mac Address - Avaya 3500 series Getting Started

Getting started fundamentals
10. Enter the in-band IPv6 address at the following prompt:
11. Enter the in-band IPv6 default gateway at the following prompt:
Example
###############################################################################
Welcome to the 3526T-PWR+ setup utility.
You will be requested to provide the switch basic connectivity settings.
After entering the requested info, the configuration will be applied and
stored into the switch NVRAM.
Once the basic connectivity settings are applied, additional configuration
can be done using the available management interfaces.
Use Ctrl+C to abort the configuration at any time.
###############################################################################
Please provide the in-band IP Address[0.0.0.0]:
Please provide the in-band sub-net mask[0.0.0.0]:
Please provide the Default Gateway[0.0.0.0]:
Please provide the Read-Only Community String[**********]:
Please provide the Read-Write Community String[**********]:
Please provide the Quick Start VLAN <1-4094> [1]:
Please provide the in-band IPV6 Address/Prefix_length[::/0]:
Please provide the in-band IPV6 Default Gateway[::]:
###############################################################################
Basic switch parameters have now been configured and saved.
###############################################################################

BootP automatic IP configuration and MAC address

The Ethernet Routing Switch 3500 Series has a unique 48-bit hardware address, or MAC
address, that is printed on a label on the back panel. You can use this MAC address when you
configure the network BootP server to recognize the Ethernet Routing Switch 3500 Series
BootP requests. A properly configured BootP server lets the switch automatically learns its
assigned IP address, subnet mask, IP address of the default router (default gateway), and
software image file name.
20 Getting Started
Please provide the in-band IPV6 Address/Prefix_length
[ : :/0]:
Please provide the in-band IPV6 Default Gateway [ : :]:
Successful completion displays the following message: Basic switch
parameters have been configured and saved.
Comments? infodev@avaya.com
March 2013